Dinstar DWG2000 Series - Functions and Features; Supported Protocols and System Functions

DWG2000 GSM/CDMA/WCDMA User
Manual
8
Copyright @ 2015
1
Power
Connector
Power connector of DC power. Input: DC12V
2
Antenna
Connector
Mark as digits 0 to 7
3
Network
FE0 and FE1, its default IP address 192.168.11.1
4
Console
RS232 standard, band rate 115200bps
5
RST
Reset button to restore default IP and password or
restore factory setting.
 Restore IP and Password: hold RST button 3~5
seconds, RUN LED being ON during this time
 Restore factory setting: Hold RST button 7 seconds,
RUN LED being blink
1.4 Functions and Features
1.4.1 Protocols Supported
 Standard SIP
 Simple Traversal of UDP over NATs (STUN)
 Point-to-point Protocol over Ethernet (PPPoE)
 Hypertext Transfer Protocol (HTTP)
 Dynamic Host Configuration Protocol (DHCP)
 Domain Name System (DNS)
 ITU-T G.711α-Law/μ-Law, G.723.1, G.729AB
1.4.2 System Function
 PLC: Packet Loss Concealment
 VAD: Voice Activity Detection
 CNG: Comfort Noise Generation
 Local/Remote SIM Card Working Mode
 Adjustable Gain of Port
 DTMF Adjustment
 Balance Check
 Lock/Unlock SIM/UIM
 Rejection of Mobile Number Display
 Sending/Receiving SMS
 Customized IVR Recording
 White and Black Lists
 One Number Access