22
The Attendant Bluetooth Weight Indicator allows several operational parameters to be
reviewed and changed as necessary without having to enter the setup mode.
To Enter Setup Review:
1. If indicator is on, press ON/OFF key.
2. Display will show oFF and indicator will turn off.
3. Press and hold ENTER/PRINT key and then press ON/OFF key.
4. Indicator will perform a lamp test (turn on all segments of display), display model
number and software revision and then display PUO prompt.
5. With display showing PUO, release ENTER/PRINT key.
6. Refer to instructions listed in Setup and Calibration section for information on how
to change parameters.
Parameters in Setup Review will be processed in the following sequence:
PUO Enable or disable automatic reset of weight display to zero on power up
baud= Select baud rate for serial output
niCAd Select to use Ni-Cad, NiMH or Alkaline batteries and type of charging
SLeeP Disable or select number of minutes of inactivity at zero for sleep mode
ASH Disable or select number of minutes for automatic shutoff timer
Setup Review, Bluetooth Pairing
Bluetooth Pairing
Bluetooth capability on the Attendant Bluetooth Weight Indicator is always active.
To pair a Bluetooth-capable device with the scale, select the name of the scale from the
list of available connections: 750DS2 SCALE XXXX. XXXX represent the last four digits
of the Attendant Bluetooth Weight Indicator serial number. The serial number of the
unit is located on a label on the top side of the indicator.
When a stable weight reading is achieved, and if the scale is paired with a Bluetooth-
capable device, the reading will transmit when the device sends a request to receive
data.
To Next Page
Loading...
