Direct Supply Attendant - Event Counter and Device Maintenance; Event Counter Features; Care and Cleaning Instructions

24
Event Counter and Care & Cleaning
Event Counter
The Attendant Bluetooth Weight Indicator has been designed with an Event Counter type
of security seal. When selected, the Attendant Bluetooth Weight Indicator will display two
three digit numbers representing the Calibration and Configuration counters.
Calibration Counter
The calibration counter is incremented when a value in the calibration part of setup
is changed (USA, int, Unit, trA, UnS, dPP, CAP, FLt, F , br, Sr, CAL, SetGC,
CALGC, OPGC). The counter is only incremented one time even if more than one
parameter is changed each time through setup.
Configuration Counter
The configuration counter is incremented when a value in the configuration part
of setup is changed (Hold, bAnd, PUO, niCAd, SLEEP, ASH). The counter is
only incremented one time even if more than one parameter is changed each time
through setup.
To Review the Event Counter:
1. If indicator is on, press ON/OFF key.
2. Display will show oFF and indicator will turn off.
3. Press and hold the UNITS key and then press ON/OFF key.
4. The display will then show CAL CH (Calibration Check) for two (2) seconds
followed by two three digit numbers.
• The left number represents the setup Configuration counter.
• The right number represents the Calibration counter.
5. To return to the normal operation, press the UNITS key.
6. Otherwise press the ON/OFF key to turn off the indicator.
Care & Cleaning
Carefully inspect the device prior to each use. Do NOT use if the device appears to be
damaged or not functioning correctly
• DO NOT submerge indicator in water, pour or spray water directly on indicator.
• DO NOT use acetone, thinner or other volatile solvents for cleaning.
• DO NOT expose equipment to temperature extremes.
• DO NOT place equipment in front of heating/cooling vents.
• DO clean the indicator with a damp soft cloth and mild non-abrasive detergent.
• DO remove power before cleaning with a damp cloth.
• DO provide clean AC power and adequate protection against lightning damage.
• DO keep the surroundings clear to provide clean and adequate air circulation.