To Next PageTo Next PageWhat to do if my Direct Supply Medical Equipment motor runs, but there is no vacuum?
If your Direct Supply Medical Equipment motor is running but there's no vacuum, first, make sure the tubing connections are secure. Then, check for any leaks or kinks in the tubing. Also, verify that the float shut-off hasn't been activated. Finally, inspect the system for any leaks or cracks.
General| Brand | Direct Supply |
|---|---|
| Model | Attendant |
| Category | Accessories |
| Language | English |
Explains meanings of notes, cautions, warnings, and user roles.
Provides safety instructions and emphasizes consulting a medical professional.
Details FCC regulations for radio frequency emissions and user responsibilities.
Instructs on environmentally responsible disposal of electronic equipment.
Lists key functionalities like Metric Conversion and BMI Calculation.
Lists optional functionalities like Bluetooth transmission and Sleep Mode.
Outlines environmental conditions for optimal performance, including temperature and air circulation.
Specifies power requirements, outlet considerations, and wiring compliance.
Guides on safely unpacking and inspecting the indicator for damage.
Details how to attach the indicator to the scale mounting bracket.
Explains how to connect the load cell cable using the 9-pin "D" connector.
Provides specific assembly instructions for wheelchair scales.
Details the use of the optional 12 VDC AC power adapter.
Explains battery levels, charging, and low battery indicators.
Explains the function of the ON/OFF and ZERO keys on the keypad.
Describes how to change weighing units and lock/unlock the display.
Details the BMI key, arrow keys for navigation, and ENTER/PRINT for data entry.
Explains the low battery annunciator located in the upper-left corner.
Details indicators like STABLE, ZERO, LOCK, kg, lb, cm, FEET, INCHES.
Step-by-step guide for performing a basic weight measurement and zeroing the display.
How to switch units and detailed steps for weighing a patient and calculating BMI.
How to review the last 10 recorded weights.
Information on storing up to 200 records with ID, weight, height, BMI, and unit.
Instructions to enter setup mode using the calibration switch and ON/OFF key.
Setting to select between US domestic or international zero limit configuration.
Configuration for weighing interval, units, and automatic zeroing range.
Settings for unstable range, decimal position, and scale capacity.
Settings for digital filter level, break range, and sample rate.
Instructions to start the calibration process by selecting Yes/No.
Guides on applying calibrated test weights for load calibration.
Instructs to remove test weights and save calibration data.
Option to calibrate for local gravity acceleration, enabling or disabling the feature.
Displays/sets gravity values for calibration and operation locations.
Configures the hold feature for locking weight display, including manual and automatic modes.
Settings for auto lock reset threshold and automatic power-up zero.
Sets serial output baud rate and battery type for charging.
Enables or disables sleep mode to conserve battery power during inactivity.
Configures automatic shutoff after inactivity to prolong battery life.
Final step indicating completion of setup and calibration process.
Instructions on how to access the setup review mode to view/change parameters.
Information on how Bluetooth capability is always active and how to pair devices.
Lists error and status display codes with their corresponding meanings.
Troubleshooting guide for common problems like display not turning on or incorrect weight.
Explains the security seal feature with calibration and configuration counters.
Provides instructions for cleaning and maintaining the indicator.
Lists all components of the indicator with their quantities and descriptions.
Illustrates the physical layout of the indicator's parts with numerical labels.
Provides a diagram of the indicator mounting bracket assembly.
Outlines the warranty period, conditions, exclusions, and liabilities.
Specifies the anticipated usable device life based on normal use and maintenance.
Provides distributor contact information for questions and warranty service.
