Direct Supply Attendant - Operational Settings: Lock, Baud, and Battery; Auto Lock Reset Band & Power Up Zero; Serial Baud Rate & Battery Type Selection

20
bAnd= (AUTO LOCK RESET BAND)
If Auto Lock is selected, the display will change to show the bAnd= (Auto Lock
Reset Band) prompt. This is the number of division changes needed to reset the auto
lock. For the Auto Lock to function, the load on the scale must rise above the bAnd=
value (and remain stable). To release Auto Lock, the load on the scale must fall below
the bAnd= value. At that point, the next weighing operation can begin.
Press the ENTER/PRINT key to view the current setting. If the value displayed is
acceptable, press the ENTER/PRINT key again. Otherwise, press the or keys
and the or keys to scroll through and select a new value and then press the
ENTER/PRINT key to save it and proceed to the next prompt. Allowable values are: 0
through 99.
PUO= (Power Up Zero)
Press the ENTER/PRINT key to view the current setting. If the value displayed is
acceptable, press the ENTER/PRINT key again. Otherwise, press the or keys to
scroll through and select a new value and then press the ENTER/PRINT key to save
it and proceed to the next prompt. Allowable values are: 0 or 1.
0 = weight display will not be
reset to zero on power up
1 = Weight display will be reset to zero
automatically on power up
BAUD= (SERIAL OUTPUT BAUD RATE)
Press the ENTER/PRINT key to view the current setting. If value displayed is
acceptable, press ENTER/PRINT key to save it. Otherwise, press the or keys to
scroll through and select a new value and then press the ENTER/PRINT key to save
it and proceed to the next prompt. Allowable values are: 1, 2, 3 or 4.
1 = 4800 Baud 2 = 9600 Baud 3 = 19.2k Baud 4 = 38.4k Baud
niCAd (Battery Type Selection)
This setting determines whether Alkaline, NiCad or NiMH batteries are used for
battery operation.
Press the ENTER/PRINT key to view the current setting. If the value displayed is
acceptable, press the ENTER/PRINT key again. Otherwise, press the or keys to
scroll through and select a new value and then press the ENTER/PRINT key to save
it and proceed to the next prompt. Allowable values are: 0, 1 or 2.
0 = Alkaline batteries – battery charging is DISABLED
1 = NiCad or NiMH batteries – battery charging is ENABLED
2 = Battery charging is ENABLED and FORCED ON. This selection forces
battery charging for NiCad or NiMH batteries that are discharged.
Setup & Calibration (cont.)