To Next Page

To Previous Page

long term event history

The control module will store the last 2 triggers in memory that are not erased when

the ignition is turned on. This can be helpful for trouble shooting false alarm reports.

To access the event history use the following procedure.

1. Turn the ignition switch off and press and hold the integrated LED/Valet

switch.

2. While holding the integrated LED/Valet

switch turn the ignition On.

3. Release the integrated LED/Valet

switch.

4. Within 5-seconds, press and release the integrated LED/Valet

switch.

The LED will flash in groups indicating the last two zones reported triggered. For

example, if zone 2 and 3 were the last two zones to be triggered, the LED will flash

two times followed by a pause and then flash three times followed by a pause.

NNOOTTEE::

The Warn Away

response does not report on the LED.

The Long Term Event History will exit if the ignition is turned off or there is no activity

for 60-seconds.

rapid resume logic

The current state of the alarm will be stored in non-volatile memory. If power is lost

and then reconnected, the system will recall the stored state from memory (arm, dis-

arm, and Valet

mode).

Directed Electronics AM1 Installation Guide

Other manuals for Directed Electronics AM1