26
© 2005 directed electronics, inc.
feature programming
The feature programming routine is used to access and change any of the feature set-
tings in the two menus below. The feature settings can be accessed and changed by
using one of the following:
z
The integrated LED/Valet
®
switch to enter the feature programming routine.
z
Use of the Directed Electronics Bitwriter
®
is recommended. Expanded program-
ming options are only available when using the Directed Electronics Bitwriter
®
.
NNOOTTEE::
If Feature Programming Lockout is set to ON, all features will be locked and
can
OONNLLYY
be accessed by using a Bitwriter
®
.
to enter feature programming routine
1. Open a door.
2. Turn the ignition on and then off.
3. Close the door.
4. Within 5-seconds, press and HOLD the integrated LED/Valet
®
switch. After 3-sec-
onds the horn will sound once to indicate entry into the first features menu. To select
the second features menu, continue to hold the integrated LED/Valet
®
switch until the
horn sounds twice. Once the desired menu is selected, release the integrated
LED/Valet
®
switch.
5. Within 5-seconds, press and release the integrated LED/Valet
®
switch the number
of times corresponding to the desired feature listed below. Then press the integrated
LED/Valet
®
switch one more time and
hhoolldd
. The horn will sound the number of times
equal to the feature number selected.
6. While holding the integrated LED/Valet
®
switch, assign the selected feature to a fac-
tory button by either pressing Lock for 1 short horn honk setting or pressing Unlock
for 2 short horn honk setting.
To Next Page
Loading...
Need help?
General
