© 2005 directed electronics, inc.
31
master dealer remotes
A master dealer remote can be programmed into the system for demonstration pur-
poses. Generally, each salesman would carry a remote that would operate all the cars
on the lot equipped with this system. The dealer remotes are binary transmitters that
are detuned slightly in order to limit transmitting range. The dealer remote can be
taught to the system by the following Transmitter Learn Routine.
master dealer remote learn routine
Since the OEM UPGRADE SECURITY SYSTEM does not ship with a receiver, programming
of the Master Dealer Remote (Directed P/N: 465D) requires the following conditions:
z
Receiver (Directed P/N: 543R and 543B) must be plugged into the 4-pin
receiver port.
z
2-pin Dealer Master Loop (Included) must be plugged into the BLACK 2-pin
Loop port.
NNOOTTEE::
Refer to Wiring Quick Reference Guide at the back of this guide for port locations.
To program the Master Dealer Remote to the OEM UPGRADE SECURITY SYSTEM:
1.
OOppeenn aa ddoooorr..
2.
KKeeyy..
Turn the ignition on.
3.
CChhoooossee..
Within 5-seconds, press and release the integrated LED/Valet
®
switch the
number of times corresponding to the desired channel listed below. Once you have
selected the channel, press the switch once more and HOLD it. The LED will flash and
the horn will honk (if connected) to confirm the selected channel. Do not release the
integrated LED/Valet
®
switch.
4.
TTrraannssmmiitt..
While holding the integrated LED/Valet
®
switch, press the button from the
transmitter that you wish to assign to the selected channel. The unit will chirp indicat-
ing successful programming. It is not possible to teach a transmitter button to the sys-
tem more than once.
To Next Page
Loading...
Need help?
General
