32
© 2005 directed electronics, inc.
5.
RReelleeaassee..
Once the transmitter is learned, the integrated LED/Valet
®
switch can be released.
When installing the system, it is possible to preset all of the operation settings using
the master dealer remote. However, when the system is operated using the master
dealer remote, a special set of dealer default settings are followed. The dealer default
settings are used to ensure that every vehicle equipped with this system is protected at
all times. All system features can be programmed to meet the installation needs but
only the settings listed below will be affected in master dealer mode.
z
Passive arming On
z
Confirmation honks off
z
Ignition lock and unlock on (if installed)
z
Passive locking (if programmed on) (“Default setting ON for Dealer
Master Mode” for passive locking.)
z
Ignition domelight on
z
Security features off (Programmable with Bitwriter)
z
Valet
®
mode disabled
These features will be set as listed and will remain so (Except Security Features) until
the master dealer mode is exited. Once the vehicle is delivered to the end user, the
dealer master loop harness should be removed. The system will then operate accord-
ing to how the operating settings have been preset. It is also possible to reprogram
the operating settings by following the feature programming section of this guide.
CChhaannnneell NNuummbbeerr FFuunnccttiioonn WWiirree CCoolloorr
1 Auto learn standard configuration N/A
2 - 8 No Function for Dealer Master Remote N/A
9 Delete all transmitters N/A
To Next Page
Loading...
Need help?
General
