34
© 2005 directed electronics, inc.
I can get into programming and change the feature settings,
but when I use the remote the settings seem to change.
• Are you using a binary, master dealer remote? Remember, you can program the
settings using a master dealer remote. However, the unit will follow the dealer
default settings when using a binary remote to operate the system.
Door Lock Learn Routine does not learn door locks.
• Check connections to be sure everything is properly connected. Refer to the
Keyless
Entry Systems—Three Types
section of this guide for correct wire connections.
• Check the
Door Lock Learn Routine
section of this guide to ensure the correct pro-
cedure is being used.
Door Lock Learn Routine does not work, the unit enters the
learn routine then chirps horn and exits.
• Some cars do not flash the parking lights with the door open. For these vehicles,
to program the unit correctly the door needs to be closed (so that the parking lights
will flash with the factory keyless system).
Unit does not learn Dealer Master Remote.
• Please refer to the
Master Dealer Remotes
section of this guide. The following two
conditions must be met in order to learn a master remote:
• A receiver (not included (543B and 543R)) MUST be connected to the
system.
• The Dealer Master Loop (included with the system) MUST be plugged in.
Unit goes into Programming every time the ignition is turned off.
• The LED/Valet
®
switch is probably stuck in the down position. If the hole for the
switch is too tight, the travel of the switch can be impaired and the switch may stick
in the down position. To allow the button to travel freely, the mounting hole must
not be too tight.
To Next Page
Loading...
Need help?
General
