To Next Page

To Previous Page

2-8 Aux 1 Validity (1)

Latched (2), Latch reset w/ignition (3), 30-sec. timed

(4)

Validity: Output that will send a signal as long as the transmission is re-•

ceived.

Latched: Output that will send a signal when the Aux 1 button is pressed •

and will continue until the same button) is pressed again.

Latched, reset with ignition: Similar to the latched output this output type •

turns ON the ﬁrst time the Aux 1 button is pressed and turns OFF the next

the same button is pressed. This output type additionally stops and resets

whenever the ignition is turned ON, and then OFF.

30-second timed: Output that will send a continuous signal for 30 sec-•

onds.

Off: Output is disabled.•

Note:

All auxiliary channel timed outputs can be programmed using the Bit-

writer® (1-90 seconds)

2-9 Aux 1 Linking, None (1)

Lock (2) Unlock (3) Lock/Unlock (4) Remote Start

(5). When programming to Validity or timed output this can be programmed to

activate when locking or unlocking (or remote start) with the transmitter.

Note: Aux linking gives you option to have the auxiliary wire activate when

locking, unlocking, locking and unlocking or with remote start.

2-10 Aux 2 Validity (1)

Latched (2), Latch reset w/ignition (3), 30-sec. timed,

(4) Output, (5) Off: Auxl 2 can be programmed for these output conﬁgurations.

The unit is set to the default validity output. To change the conﬁguration use the

two-honk setting to toggle through the different conﬁgurations. Refer to feature

2-8 for additional details

2-11 Aux 2 Linking None (1)

Arm (2) Disarm (3) Arm/Disarm (4) Remote Start

(5). Refer to feature 2-9 for additional details.

2-12 Aux 3 Validity (1)

Latched (2), Latch reset w/ignition (3), 30 -sec. timed,

(4) Output, (5) Off: Aux 3 can be programmed for these output conﬁgurations.

The unit is set to the default validity output. To change the conﬁguration use the

two-honk setting to toggle through the different conﬁgurations. Refer to feature

2-8 for additional details.

Directed Electronics Python 1401 Installation Guide

Other manuals for Directed Electronics Python 1401