15
© 2019 Directed. All rights reserved.
Any of the settings can be changed and assigned to a particular re-
mote, up to four - this is called Owner Recognition. When that particu-
lar remote is used to disarm the system, the assigned feature settings
are recalled. Owner Recognition is only possible when programming
the unit via XKLOADER3.
If the system was previously programmed using the XKLOADER3, the
Learn Routine may be locked. If the siren generates one long chirp
when attempting to program the unit, the Learn Routine is locked and
must be unlocked using XKLOADER3.
1. Open a door. The Green wire or the Violet wire of the primary
12-pin harness must be connected.
2. Turn the ignition on, then off. The Yellow wire of the primary 12-
pin harness must be connected.
3. Select a Menu. Press and hold the Control Center button.
After three seconds the siren will chirp once indicating entry to
the Features Menu 1. If this is the menu you wish to access,
release the button and go on to next step. If the button is not
released, you will jump to the Advanced Features Menu 2 and
the siren will chirp twice.
After you select the menu you want, release the Control
Center button and then proceed to the next step.
4. Select a Feature. Press and release the Control Center button
the number of times corresponding to the feature you wish to
change. For example, to access the third feature, press and
release the switch three times. Then press the switch once more
and HOLD it. The siren will chirp the number of times equal to
the step you have accessed.
5. Program the Feature. While holding the Control Center button,
you can program the feature using the remote control. Pressing
To Next Page
Loading...