5
© 2019 Directed. All rights reserved.
2
WHITE (+/- ) SELECTABLE PARKING LIGHT OUTPUT
As shipped, this White wire should be connected to the (+) parking
light wire. If the parking light polarity jumper is moved to the (-) position
(see the Parking light jumper section of this installation guide), this wire
supplies a (-) 200 mA output.
For parking light systems that draw 10 amps or more, the jumper must
be switched to a (-) parking light output (see the Parking light jumper
section of this guide). P/N 8617 or a standard automotive SPDT relay
must be used for the parking light output.
Important: DO NOT connect the white parking light output to a negative
vehicle parking light wire before changing the programming jumper to the
negative polarity position or damage to vehicle light circuit may occur.
3
WHITE/
BLUE
200mA CHANNEL 3 PROGRAMMABLE OUTPUT
This wire provides a (-) 200 mA output, whenever the remote control
button(s) controlling channel 3 output is pressed. This wire can be pro-
grammed to provide different types of outputs (see "System features
learn routine" on page 14 of this guide).
To Next Page
Loading...