To Next PageTo Next PageWhat to do for Directed 403.NISS4HT 2.39 RSR bypass processing error?
If your Directed Automobile Accessories module shows a bypass processing error, it means the bypass calculation failed. Try resetting the module and attempting the process again. If the problem persists, further assistance may be required.
Why is BCM programming failing on Directed Automobile Accessories?
If BCM programming is failing on your Directed Automobile Accessories, the doors may be locked. Ensure that the doors are unlocked, as they need to be unlocked to solve this problem.
What to do if Directed Remote Starter module has no power?
First, ensure the D2D harness is securely connected and verify that there's 12V present between the red and black wires. If the voltage is correct, the module might be defective.
What does it mean if ISO 2 is not detected on Directed 403.NISS4HT 2.39 RSR Automobile Accessories?
If ISO 2 is not detected on your Directed Automobile Accessories, it indicates that the Orange/Black wire did not detect the expected signal. You should check the connections.
What to do if Directed Remote Starter bypass data not detected?
Check the connection of the bypass line. If multiple wires are used, ensure they are not inverted. Also, make sure the vehicle still operates correctly using the factory key.
What to do if Directed Remote Starter CAN1 not detected?
Check the CAN1 Tan and Tan/Black wire connections. Wake up the data bus by turning the ignition on and try again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.
What to do if Directed Remote Starter CAN2 not detected?
Check the CAN2 Orange/Green and Orange/Brown wire connections. Wake up the data bus by turning the ignition on and try again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.
What to do if Directed Remote Starter J1850 not detected?
Check the J1850 wire connection. Wake up the data bus by turning the ignition on and try again.
What to do if Directed Remote Starter initialization failed?
Reset the module and complete the programming again. If the issue persists, please contact Technical Support.
What to do if Directed Remote Starter bypass processing error?
The bypass calculation failed. Reset the module and try again. If the condition persists, please contact Technical Support.
General| Brand | Directed |
|---|---|
| Model | 403.NISS4HT 2.39 RSR |
| Category | Automobile Accessories |
| Language | English |
