Directed DBALL2 User Manual

Platform: DBALL2
Firmware: CHRYSLER Remote Start Ready (RSR) Installation
© 2017 Directed. All rights reserved.
Rev.: 20170214
3
4
Turn the key to the OFF
position and remove it
from the ignition barrel.
Press LOCK or UNLOCK on the
factory transmitter. The LED turns
ON solid green OR orange for 3 seconds
and then turns off.
or
&
&
or
Solid
Green
Solid
Orange
Off
Key OUT
OFF
START
IG
N
or
Press the Push-to-Start
(PTS) button once more
to turn the ignition OFF.
1X
ENGINE
START
STOP
PUSH
PAN
I
C
Page 26
You have successfully completed the module programming sequence.
2
Insert the key into the ignition barrel and turn it to the ON position.
It is important to wait for the LED to start flashing green.*
* Refer to the LED Diagnostics section for troubleshooting
if the LED does not flash green within 15 seconds.
Key IN
OFF
START
ON
Vehicles WITHOUT Factory Keyless
(Refer to the previous page for programming instructions WITH factory keyless).
Press & Release
4
Press and release the programming button. The LED turns ON
solid green OR orange for 3 seconds and then turns OFF.
&
You have successfully completed the module programming sequence.
1
10-pin
D2D
st
1
12-pin
14-pin
nd
2
rd
3
Connect the 10-pin, 12-pin and 14-pin harnesses to
DBALL2, then wait until the LED turns ON solid red.
3
Turn the key to the OFF position and remove it from the ignition barrel.
&
Flashes
Green
Key OUT
OFF
START
IGN
OffSolid
Orange
Solid
Green
or
&
&
Solid

Directed DBALL2 Specifications

General

Brand	Directed
Model	DBALL2
Category	Remote Starter
Language	English