Directed Directechs DB3 - User Manual

24 pages

Save Page as PDF

To Next Page

INSTALLATION GUIDE

DB3

2020 Audi Q7 (Smart Key). 403.VW08 1.35 RSR

This product is intended for installation by a professional installer only! Attempts to install this

product by a person other than a trained professional may result in severe damage to a vehicle’s

electrical system and components.

Questions and Answers

K
Kayla ParkSep 23, 2025
Why is Directed Automobile Accessories 'waiting to begin the programming sequence'?
- T
  tarabakerSep 23, 2025
  Ensure the correct programming procedure is being followed.
L
Laura JonesSep 23, 2025
What does it mean if Directed Automobile Accessories PTS shutdown error occurred?
- N
  Natalie ThompsonSep 23, 2025
  The PTS output from the Directed module was not activated due to safety protection.
A
audrey01Sep 23, 2025
Why is my Directed Automobile Accessories waiting to begin the programming sequence?
- L
  Lisa RichardsonSep 23, 2025
  If your Directed Automobile Accessories is stuck waiting to begin the programming sequence, double-check that you're following the correct programming procedure.
D
Diane WintersSep 23, 2025
What to do if BCM programming fails on Directed Automobile Accessories?
- E
  Erica RichardsonSep 23, 2025
  If the BCM programming fails on your Directed Automobile Accessories, try clicking 'Unlock' on the OEM remote to solve the problem.
J
johnbarronSep 23, 2025
What should I do if J1850 is not detected in Directed Directechs DB3?
- H
  hhartmanSep 23, 2025
  If the J1850 is not detected by your Directed Automobile Accessories, check the J1850 wire connection. Try waking up the data bus by turning the ignition on and trying again.
C
Cynthia FieldsSep 23, 2025
Why Directed Automobile Accessories says Runsafe was not disabled?
- D
  Darrell CrossSep 23, 2025
  If the Directed Automobile Accessories system indicates that Runsafety was not disabled, it means no UNLOCK command was received before opening the door, or the 45-second timer expired in takeover mode.
T
tstevensSep 23, 2025
Why Directed Directechs DB3 says OBDII feature not supported?
- M
  Megan LeeSep 23, 2025
  If the Directed Automobile Accessories system indicates that the OBDII feature is not supported, it means the diagnostic data bus wasn't detected, which will limit SmartStart features.
Z
Zachary KelleySep 23, 2025
What to do if MUX not detected in Directed Directechs DB3 Automobile Accessories?
- P
  Phillip MaddoxSep 23, 2025
  If the Directed Automobile Accessories system indicates that the MUX was not detected, the Violet/Green or Violet/Brown wire didn't detect the expected voltage value. Check the connections.
K
Kelly BeasleySep 23, 2025
Why Directed Automobile Accessories says that brake was not detected?
- H
  hperrySep 23, 2025
  If the Directed Automobile Accessories system indicates that the brake was not detected, it prevents the system from shutting down the vehicle.
K
Karen JonesSep 23, 2025
Why Directed Directechs DB3 says that smart key was not detected?
- T
  Theresa CastroSep 23, 2025
  If the Directed Automobile Accessories system indicates that the smart key was not detected, this prevents the system from shutting down the vehicle.