Distinction PASRW030-BP2

Need help?

Do you have a question about the Distinction PASRW030-BP2 and is the answer not in the manual?

Summary

1. PREFACE

2. SPECIFICATION

2.1 Performance data of swimming pool heat pump unit

Details performance metrics like heating power, current, and water flow for different models.

2.2 Dimensions for swimming pool heat pump unit

Provides physical dimensions and specifications for the unit models.

3. INSTALLATION AND CONNECTION

3.1 Installation illustration

Schematic diagram showing the plumbing connections for the heat pump system.

3.2 Swimming pool heat pump location

Guidelines for selecting an optimal outdoor location for the heat pump unit.

3.3 How close to your pool?

Discusses the impact of distance from the pool on heat loss and piping.

3.4 Swimming pool heat pump plumbing

Details plumbing arrangements, connection types, and condensation drainage.

3.5 Swimming pool heat pump electrical wiring

Instructions for safe electrical hook-up and grounding of the unit.

3.6 Initial startup of the unit

Step-by-step guide for the initial power-up and operation of the heat pump.

4. USE AND OPERATION INSTRUCTION OF WIRE CONTROLLER

4.1 Interface display

Explains the symbols and layout of the wire controller's main display screen.

4.2 Key and icon function instruction

Details the functions of various buttons, icons, and symbols on the controller.

4.3 Startup and shutdown

Guides users on how to properly start and stop the heat pump unit via the controller.

4.4 Mode switch

Explains how to cycle through and select heating, cooling, or automatic modes.

4.5 Temperature setting

Instructions on how to adjust and set the desired pool water temperature.

4.6 Clock setting

Explains how to set the system's internal clock and timer functions.

6.1 System time setting

Detailed steps for setting the current time on the controller.

6.2 Setting and cancelling the Timer ON;OFF function

How to configure and disable automatic ON/OFF timer schedules.

4.6.2 Setting and cancellation of timing ON and OFF

Step-by-step instructions for setting and cancelling ON/OFF timer schedules.

4.7 Mute setting

How to activate and deactivate the silent operation mode for reduced noise.

4.7.1 One-click mute

Using a single button press to activate or deactivate the mute function.

7.2 Settingand cancelling the silentfunction

Procedure for programming and disabling the silent operation mode.

4.8 Keyboard lock

Instructions for locking the controller to prevent accidental changes.

4.9 Fault interface

How the controller displays error codes and information in case of unit faults.

4.10 Parameter list and breakdown table

Lists parameters and provides a fault table for troubleshooting.

4.10.1 Electronic control fault table

Details fault codes, their reasons, and elimination methods for the electronic control system.

Frequency conversion board fault table:

Lists fault codes specific to the frequency conversion board and their solutions.

4.10.2 Parameter list

Lists adjustable parameters with their default values and remarks.

5. MAINTENANCE AND INSPECTION

6. APPENDIX

6.1 Interface drawing

Diagram and definitions for the controller's input/output interfaces and main board.

6.3 Circuit diagram of the unit

Electrical schematic illustrating the internal wiring and components of the unit.

6.2 Cable specification

Specifies the required cable types and sizes for single and three-phase unit installations.

6.4 Explosive view of the unit

Exploded view diagrams showing the assembly and parts of the unit.