SK3000 Operator’s Manual Prepare - 25
Prepare Operator
Prepare Operator
Follow these guidelines before operating any jobsite equipment:
• Complete proper training and read operator’s manual before using equipment.
• Plan for emergency services. Have the telephone numbers for local emergency and medical facilities
on hand. Check that you will have access to a telephone.
• Review jobsite hazards, safety and emergency procedures, and individual responsibilities with all
personnel before work begins. Safety videos are available from your Ditch Witch dealer or at
www.ditchwitch.com/safe. Safety Data Sheets (SDS) are available at www.ditchwitch.com/support.
• Use equipment carefully. Stop operation and investigate anything that does not look or feel right.
Any time the jobsite is classified as electric, operator must wear boots and gloves meeting the following
standards:
• Boots must have high tops and meet the electric hazard protection requirements of ASTM f2413 or
ASTM F1117 when tested at 18,000 volts. Tuck legs of pants completely inside boots.
• Gloves must have 17,000 AC maximum use voltage, according to ASTM specification D120.
• If working around higher voltage, use gloves and boots with appropriately higher ratings.
Jobsite hazards. Exposure can cause death or serious
injury. Use correct equipment and work methods. Use and maintain
appropriate safety equipment.
To help avoid injury:
• Wear personal protective equipment including hard hat, safety eye wear, foot protection, hearing
protection, and gloves (except when near rotating equipment).
• Remove jewelry.
• Wear close-fitting, high visibility clothing.
• Have other personal protective equipment, such as insulated boots and gloves, breathing
protection, and face shield, etc. available for use depending on jobsite hazards or requirements.
To Next Page
Loading...
Need help?
General
