SK3000 Operator’s Manual Maintenance - 87
Procedures
Fuse Box
Check fuse box cover for damage before startup.
If cover is missing or damaged, replace.
Hydraulic Hoses
Check for leaks where shown before startup and
every 10 hours of operation.
IMPORTANT: Leave cover in place unless fuses
are being checked or replaced.
Pressurized fluid or air. Injection can cause death or
serious injury. Refer to operator’s manual for correct use.
To help avoid injury:
• Use a piece of cardboard or wood, rather than hands, to check for leaks.
• Before disconnecting a hydraulic line, turn engine off and operate all controls to relieve pressure.
• Lower, block, or support any raised component with a hoist.
• Cover connection with heavy cloth and loosen connector nut slightly to relieve residual pressure.
Catch all fluid in a container.
• Before using system, check that all connections are tight and all lines are undamaged.
• If you are injured, seek immediate medical attention from a doctor familiar with this type of injury.
t62om053w19.eps
To Next Page
Loading...
Need help?
General
