SK3000 Operator’s Manual Drive - 57
Shut Down
Reduce Track Wear
Rubber tracks are best suited at soil-based jobsites with minimal rocks and debris. To reduce track wear
drive slowly and make wide turns. Avoid the following:
• spinning tracks under heavy load
• turning on sharp objects such as stones, broken concrete, or debris
• quick turns on asphalt or concrete
• driving over curbs or ledges
• driving with track edges pressed against hard walls or curbs
• operating on corrosive materials such as salt or fertilizer
Shut Down
1. When job is complete, move machine to level ground.
2. Stop machine movement.
3. Set parking brake.
4. Lower lift arms to ground.
5. Return all controls to neutral.
6. Run engine at low throttle with no load for at least five minutes to cool.
7. Shut off machine.
8. If leaving machine unattended, lock machine.
9. For maintenance or long-term storage, disconnect battery using battery disconnect switch.
NOTICE: Wait two minutes after shutting off machine before disconnecting battery.
To Next Page
Loading...
