SK3000 Operator’s Manual Prepare - 29
Prepare Equipment
Hydraulic Connection
If attachment requires hydraulic power for operation, connect hydraulic hoses.
1. Ensure machine is shut off.
2. Activate accessories using ignition switch.
3. Operate auxiliary controls to relieve residual
pressure at hydraulic couplers.
4. Remove dirt and debris from hydraulic
couplers.
5. Connect male coupler on attachment to
female coupler (3) on machine.
6. Connect female coupler from attachment to
male coupler (1) on machine.
7. If needed, connect attachment case drain
hose to case drain connector (2).
8. Ensure that connections are secure by pulling
on hoses.
Pressurized fluid or air. Injection can cause death or
serious injury. Refer to operator’s manual for correct use.
To help avoid injury:
• Use a piece of cardboard or wood, rather than hands, to check for leaks.
• Before disconnecting a hydraulic line, turn engine off and operate all controls to relieve pressure.
• Lower, block, or support any raised component with a hoist.
• Cover connection with heavy cloth and loosen connector nut slightly to relieve residual pressure.
Catch all fluid in a container.
• Before using system, check that all connections are tight and all lines are undamaged.
• If you are injured, seek immediate medical attention from a doctor familiar with this type of injury.
Hot parts. Contact can cause burns. Only touch when cool
or wear gloves.
IMPORTANT: Right side is medium flow and left side is high/low flow.
1
2
3
t62om010w19.eps
To Next Page
Loading...
Need help?
General
