Transport - 66 SK3000 Operator’s Manual
Retrieve
8. If engine will start, release parking brake.
If engine will not start, disconnect brake hose
(shown) and connect to external power pack
to provide hydraulic pressure to release
parking brake.
9. Cap port on brake valve.
10. Remove blocks.
11. Reconnect brake hose, if required.
12. Reconnect hoses to ground drive pump.
13. Remove blocks.
NOTICE: Do not exceed 400psi
(27.6bar).
IMPORTANT:
• If brake hose is disconnected,
machine will have no brakes.
• Ensure machine is shut off.
• Maintain hydraulic flow during
retrieval.
t62om048w19.eps
To Next Page
Loading...
