EasyManuals Logo

Ditch Witch SK3000 User Manual

Ditch Witch SK3000
103 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #81 background imageLoading...
Page #81 background image
Maintenance - 80 SK3000 Operator’s Manual
Procedures
Check every 10 hours. Charge as needed.
Check
1. Disconnect battery at battery disconnect
switch, if equipped.
2. Ensure no ignition sources are near battery.
3. Loosen and remove battery cable clamps
carefully, negative (-) cable first.
4. Clean cable clamps and terminals to remove
dull glaze.
5. Check for signs of internal corrosion in cables.
6. Connect battery cable clamps, positive (+)
cable first.
7. Tighten any loose connections.
8. Ensure that battery tiedowns are secure.
9. Turn battery disconnect, if equipped, on.
NOTICE:
Electronic components can be easily damaged by electrical surges. Jump starting can damage
electronics and electrical systems, and is not recommended. Try to charge the battery instead. Use
quality large diameter jumper cables capable of carrying high currents (400 amps or more). Low
quality cables may not allow enough current flow to charge a dead/discharged battery.
Read all steps thoroughly and review illustration before performing procedure.
t62om040w19.eps

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ditch Witch SK3000 and is the answer not in the manual?

Ditch Witch SK3000 Specifications

General IconGeneral
Engine MakeKubota
Fuel TypeDiesel
Engine Power74 hp
Lift Height132 in (3353 mm)
Gross Power74 hp
Height to Hinge Pin132 in (3353 mm)
Horsepower74 hp

Related product manuals