VP30 Operator’s Manual Plow - 51
Set Up
Position Plow
1. Start pedestrian vibratory plow. See “Start”
on page 38.
2. Drive to starting point. Move in line with
planned trench. See “Drive” on page 39.
3. Set parking pin.
4. Lower plow to starting point of trench.
5. Turn ignition switch to STOP.
Load Reel Carrier
1. Turn ignition switch to STOP.
2. Remove pins (2).
3. Install arbor (1) into spool.
4. After installing arbor, insert pins.
NOTICE: Maximum weight is 210 lb
(95.25 kg).
11
22
t56om040h.epst56om040h.eps
To Next Page
Loading...