VP30 Operator’s Manual Drill - 67
Operate
Remove Rod
If the length of rod outside the bore reaches 30’ (9 m), ask a helper to remove rod sections as needed.
Remove Rod Section
1. Stop rotation of drilling attachment.
2. Shut down machine. See page 41 for proper shutdown procedures.
3. Disconnect and remove appropriate rod section with special tool (p/n 351-272). See “Disassemble Drill
String” on page 69.
Rotating shaft will cause death or serious injury. Stay
away.
To help avoid injury:
• Only access drill string with hands when machine is shut down.
• Always remove second rod (as shown). Leave first rod section attached to drilling attachment.
To Next Page
Loading...