Ditch Witch VP30 - Operate

Plow - 52 VP30 Operator’s Manual
Set Up
Attach Product
Pull Product
1. Insert material into pulling grip.
2. Tape grip with duct tape.
Feed Product
1. Remove cable guide.
2. Feed cable through tube from top to
bottom.
3. Replace cable guide and tighten
fasteners.
4. Secure cable.
Prepare Plow
1. Start pedestrian vibratory plow. See “Start”
on page 38.
2. Release parking pin.
NOTICE: Use only genuine Ditch Witch
®
cable guide.