VP30 Operator’s Manual Plow - 53
Operate
Operate
1. Move speed direction controls to begin moving machine backward.
2. Use plow lift control to lower plow blade as machine moves backward.
3. Move throttle to at least 1/2 open.
4. Pull plow vibrator control toward operator and push down into plow position to start plow vibration.
PLOW WILL VIBRATE.
5. Adjust plow vibrator and ground drive speeds as needed. If using vibrator speed control, move ground
drive to maximum speed and use vibrator speed control to make finer adjustments as conditions
warrant.
6. Check cable for damage during plowing.
Crushing weight could cause death or serious injury. Stay
away.
To help avoid injury: Keep everyone at least 6’ (1.8 m) from machine, attachments, and their range of
movement.
Electric shock will cause death or serious injury. Stay
away.
To help avoid injury: Expose lines by hand before digging. Cutting high voltage cable can cause
electrocution.
Read operator’s manual. Know how to use all controls.
Your safety is at stake.
IMPORTANT: Plowing movement is toward operator.
NOTICE: Do not operate vibrator unless plow is in the ground.
To Next Page
Loading...