Plow - 54 VP30 Operator’s Manual
Finish Job
Finish Job
1. When trench is complete, raise plow to ground level while reducing vibrator speed..
2. Release plow vibrator control to stop vibration.
3. Continue raising plow.
4. Set parking pin.
5. Turn ignition switch to STOP and remove product from plow.
6. Turn ignition switch to ON.
7. Release parking pin.
8. Drive a short distance away from work site.
9. Shut down machine. See “Shut Down” on page 41.
NOTICE: Do not operate vibrator when plow is out of the ground.
To Next Page
Loading...