Drill - 58 VP30 Operator’s Manual
Set Up
Install Drilling Attachment
The operating position of the Roto Witch
®
drilling attachment is on the right side of the
machine.
1. Ensure engine is shut down.
2. Remove attachment from storage position.
For storage position, see “Remove Drilling
Attachment” on page 69.
3. Fully insert mount pin (2) in boss of knuckle
(1) at correct angle: drilling attachment
must be aligned with drill string.
4. Secure the assembly with pin (3).
5. Use slip latch to attach drill string to drilling
attachment.
Connect Hydraulic Lines
1. Ensure engine is shut down. Remove dust
covers from connectors (2).
2. Disconnect quick attach connectors from
plow connections (1) and connect to
drilling attachment connections (2).
11
22
33
RW_Mounting.epsRW_Mounting.eps
11
22
t56om036h.epst56om036h.eps
To Next Page
Loading...