VP30 Operator’s Manual Drill - 59
Set Up
Install Drill String
1. Assemble at least 20’ (6 m), but not more than 30’ (9 m), of drill rod sections.
2. Install drill bit to the cutting end of the drill string.
3. Put drill string in approach trench and align with intended bore path.
4. Start engine and set to low throttle. See “Start” on page 38.
5. Raise attachment to highest position.
6. Move machine toward approach trench. See “Drive” on page 39.
7. Shut down engine. See “Shut Down” on page 41.
NOTICE: Incorrect installation can cause rod sections to bend.
• Ensure more than half of drill string length is inside trench.
• If necessary, remove rod sections or increase length of trench.
To Next Page
Loading...