Service - 84 VP30 Operator’s Manual
100 Hour
100 Hour
Machine
Change Engine Oil and Filter
Change engine oil every 100 hours.
To change:
1. While oil is warm, remove drain plug (1).
Drain oil and replace plug.
2. Remove filter (3) and replace with new filter
each time oil is changed. Add GEO at fill neck
(2) until oil level is at highest capacity on
dipstick. Capacity is 78 oz (2.3 L).
Check Spark Plug
Check spark plug gap every 100 hours. Correct
spark plug gap (A) is 0.030” (0.76 mm).
See engine service manual for specific procedure
and recommended replacement spark plugs.
Location Task Notes
MACHINE Change engine oil and filter GEO
Check spark plug
Change air filter
PLOW Change plow vibrator oil Initial, MPL
IMPORTANT: See “Recommended Lubricants/
Service Key” on page 77.
To Next Page
Loading...