3
IP2160EN
General safety precautions
This installation manual is intended for qualified personnel only • Installation, electrical connections
and adjustments must be performed by qualified personnel, in accordance with Good Working
Methods and in compliance with the current regulations • Read the instructions carefully before
installing the product. Wrong installation could be dangerous • Before installing the product, make
sure it is in perfect condition.
The packaging materials (plastic, polystyrene, etc.) should not be discarded in the environment
or left within reach of children, as they are a potential source of danger • Do not install the
product in explosive areas and atmospheres: the presence of inflammable gas or fumes represents
a serious safety hazard • Make sure that the temperature range indicated in the technical speci-
fications is compatible with the installation site • Before installing the motorization device, make
sure that the existing structure, as well as all the support and guide elements, are up to standards
in terms of strength and stability. Verify the stability and smooth mobility of the guided part, and
make sure that no risks of fall or derailment subsist. Make all the necessary structural modifications
to create safety clearance and to guard or isolate all the crushing, shearing, trapping and general
hazardous areas • The motorization device manufacturer is not responsible for failure to observe
Good Working Methods when building the frames to be motorized, or for any deformation during
use • The safety devices (photocells, safety edges, emergency stops, etc.) must be installed taking
into account the applicable laws and directives, Good Working Methods, installation premises,
system operating logic and the forces developed by the motorized door or gate • The safety devices
must protect against crushing, cutting, trapping and general danger areas of the motorized door
or gate. Display the signs required by law to identify hazardous areas • Each installation must
bear a visible indication of the data identifying the motorized door or gate • Before connecting the
power supply, make sure the plate data correspond to those of the mains power supply. An omnipolar
disconnection switch with a contact opening distance of at least 3 mm must be fitted on the mains
supply. Check that there is an adequate residual current circuit breaker and a suitable overcurrent
cutout upstream of the electrical installation in accordance with Good Working Methods and with
the laws in force • When requested, connect the motorized door or gate to an effective earthing
system that complies with the current safety standards • Before commissioning the installation
to the end user, make sure that the automation is adequately adjusted in order to satisfy all the
functional and safety requirements, and that all the command, safety, and manual release devices
operate correctly.
During maintenance and repair operations, cut off the power supply before opening the
cover to access the electrical parts • The protection cover of the operator must be removed
by qualified personnel only.
The electronic parts must be handled using earthed antistatic conductive arms. The manu-
facturer of the motorization declines all responsibility if component parts not compatible with
safe and correct operation are fitted • Only use original spare parts for repairing or replacing prod-
ucts • The installer must supply all information concerning the automatic, manual and emergency
operation of the motorized door or gate, and must provide the user with the operation and safety
instructions.
ATTENTION! Important safety instructions.Please follow these instructions carefully.
Failure to observe the information given in this manual may lead to severe personal injury or
damage to the equipment.Keep these instructions for future reference.
This manual and those for any accessories can be downloaded from www.ditecautomations.com
To Next Page
Loading...
Need help?
General
