PROGRAMMING P-SERIES
Page 15 of 78
C-F – COIN FILL MECH
This function is used to count coins loaded in the top (separator) of the coin mech. When “Fill Coin Mech”
is displayed the coin mech will accept tubed coins. When the first coin is inserted, “Fill Coin Mech” will be
replaced with the cash value of coins in the coin tubes. The total value of the coins inserted will be
displayed and will be counted in the DEX audit data, so the controller knows exactly how much change is
in the coin mech.
Press & hold select buttons 1 & 2 simultaneously to move to the next item on the menu.
C-D - COIN DUMP
This function is used to dump coins from the coin mechanism. Press select button 1 to enter mode and
the lowest coin value dispensable will show on the display. Press and hold select buttons 1 & 2
simultaneously to scroll through the different coin values available to dump coins. Press and hold select
button 1 to dispense the coins whose value is shown on the display. Press and hold select buttons 1 & 2
simultaneously until “Return”(RTN) shows on the display. Press select button 1 will return to “Dump Coin
Mech”.
Note: If a level 3 coin mech with Alternate Payout mode is installed, the coin mech will
stop dispensing coins when the coin mech’s coin count reaches 0.
CR – COIN RULES
This condition is used to allow the exact change condition to be turned on or off. When off, the controller
will not go in the exact change condition. This will allow bills or coins to be accepted regardless of the
ability to pay back non-refundable currency. When turned on, the controller will set the exact change
condition based on the ability to pay back non-refundable currency (i.e. Coins, paper). To show current
condition press select button 1. Press and hold select button 1 to toggle “Coin Rules” between “On” and
“Off”.
ESC - ESCROW
This function supports 4 (four) escrow options. Pressing select button 1 will show the current escrow
setting. Press and hold select button 1 to scroll through the available escrow options. To set the escrow
mode, release select button 1 when the desired setting is displayed.
PR
– ESCROW TO PRICE
This escrow condition is forced vend option 1 (“escrow to price”). All dollar bills will be stacked.
No cancel sale is allowed once minimum vend price is met or exceeded.
EP 2 – ESCROW NO CANCEL
This escrow condition is forced vend option 2 (“escrow no cancel”) with all bills stacked, and no
cancel sale allowed unless the vender is in exact change and the maximum vend price is
exceeded. Note: Any money entered below the vend price cannot be returned.
ES 4 – Escrow to Select 4
This escrow condition is “escrow to select” with all the dollar bills being stacked. Cancel sale will
return the deposit from the coin changer (i.e.4 quarters).
ES 1 – Escrow to Select 1
This escrow condition is “escrow to select dollar bills” with the last dollar bill that meets or
exceeds maximum vend price being escrowed in the note acceptor. Cancel sale will return the
held dollar bill and any amount over $1 will be returned from the coin changer.
Press & hold select buttons 1 & 2 simultaneously to move to the next item on the menu.
To Next Page
Loading...
