PROGRAMMING P-SERIES
Page 25 of 78
RTN – Return
Press select button 1 to return to “Free Vend”.
Press & hold select buttons 1 & 2 simultaneously to move to the next item on the menu.
OVER - OVERRIDE
This function is used to allow a key switch to override some of the settings stored for normal operations.
When enabled and the free vend switch is in the closed position, the controller will override “Free”,
disable vending, disable currency acceptance, display will show “No Sales”, and lights will be off. The
compressor will continue to keep product at the programmed temperature. Vender will remain in this state
until the override switch is in the open position.
Press select button 1 and the display will show the current setting for 2 seconds (ON or Off).
Press and hold select button 1 to toggle between “On”-enabled and “Off”- disabled.
Release the select button showing the setting you wish to use and display will return to “Override”.
To move to Sales Message, press & hold select buttons 1 & 2 simultaneously.
SSM – SALES MESSAGE
This function is used to turn on the scrolling message “Ice Cold Drink”.
Press select button 1 and the display will show the current setting (On or Off).
Press and hold select button 1 to toggle between “On” or “Off”.
Release the select button showing the setting you wish to use and display will return to “SSM”.
Press select buttons 1 & 2 simultaneously to scroll to “R-CH”.
R-CH – Recharge The installed Card Reader must support this option for this
feature to work correctly.
This function is used to enable the recharge card setting routine.
Press select button 1 and the display will show the current setting (On- recharge card enabled or Off-
recharge card disabled). Press and hold select button 1 to toggle between “On” and “Off ”.
Release the select button showing the setting you wish to use and display will return to “R-C4”.
Press select buttons 1 & 2 simultaneously to scroll “RTN”
RTN - RETURN
Press select button 1 to return to “User”.
Press & hold select buttons 1 & 2 simultaneously to move to the next item on the menu.
DIAG - DIAGNOSTICS
This function allows you to systematically diagnose problems related to the vender. To move to “Auto” press
select buttons 1 & 2 simultaneously, to enter sub-menu press select button 1. The following are sub-menus of
Diagnostics Menu:
Vender with DC motors (SL) “Selection”, (HS) “Home Sensor”, (VSNS) “Vend Sensors”, (MT) “Motors”,
(CM) “Coin mech”, (NA) “Note Acceptor”, (DSP) “Display”, (RLY) “Relay”, “Jog”, (PRM) “Prime”, and
(RTN) “Return”.
SL - SELECTION
Press any select button, and the display will indicate the number of the select button pressed.
Press & hold select buttons 1 & 2 simultaneously to the next item on the menu.
To Next Page
Loading...
