Dixie Narco P Series - Page 26

PROGRAMMING P-SERIES
Page 26 of 78
HS – HOME SENSOR This prompt only appears on P-Series machines.
Use this to test the home sensor on the motor for any column. Press select button 1 to display “COL 1”.
Press & hold select buttons 1 & 2 simultaneously to scroll through the columns and (RTN). Press button 1
when a column is displayed will cause the displayed column to test that the motor’s home sensor can be
detected. Press select button 1 at “RTN” to return to “HS”.
Press & hold select buttons 1 & 2 simultaneously to move to the next item on the menu.
VSNS
– VEND SENSOR This prompt only appears on P-Series machines.
Use this to test vend sensor in the machine. Press select button 1 to begin the test and “TEST CHUTE”
will be displayed. Touch or place an object on the chute. When it is detected “Chute Pass” will be
displayed. If nothing is detected on the chute, a “CHUT” message will be displayed.
Press & hold select buttons 1 & 2 simultaneously to move to the next item on the menu.
MT- MOTOR TEST
Use this test to run any motor in the stack. Press select button 1 and “MT 1” will show on the display. Use
the following select buttons to run this test.
Press Select Buttons 1 & 2: Press until desired motor # to run or (RTN) is shown on the display.
Press Select Button 1: Press to run the selected motor. The display will show “Vending” and the
selected motor will run. Note: When testing a P-Series machine, product
MUST
be seen by the vend sensor for the test to be successful.
CM – COIN MECH
Use this test to check coin mech, coin chute, and the coin mech payout systems. Inserting any coins
enters the coin mech diagnostic function. Only tubed coins (i.e. that can be returned) will be accepted.
The value of the coins will be reflected on the display. Press select button 2 will exit the test and return
any coins inserted and return to “CM”.
Press select buttons 1 & 2 simultaneously to move to the next item on the menu.
NA – NOTE ACCEPTOR
Use this test to check the note acceptor. Inserting a bill enters the note accepter diagnostic function. Bill
will be held in escrow. Press select button 2 to stack the bill. Press select button 3 to return the bill. After
the note is has been stacked or returned, the display will return to “NA”.
Press & hold select buttons 1 & 2 simultaneously to move to the next item on the menu.
DSP - DISPLAY
Press select button 1 and the display segments will illuminate in a scrolling manner, or will scroll through
a set of text characters and return to “DSP”.
Press & hold select buttons 1 & 2 simultaneously to move to the next item on the menu.