dji FLYCART 30 - Page 21

DJI FlyCart 30 User Manual
©
2024 DJI All Rights Reserved.
21
The battery level indicators display the battery level of the controller.
Blinking Patterns Battery Level
88%~100%
75%~87%
63%~74%
50%~62%
38%~49%
25%~37%
13%~24%
0%~12%
Remote Controller Alert
The remote controller vibrates or beeps twice to indicate an error or warning. For detailed
information, see the real-time prompts on the touchscreen or in the DJI Pilot 2 app. To disable
some alerts, slide down from the top and select Do Not Disturb in Quick Settings.
Any voice prompts and alerts will be disabled in Silent mode, including alerts during RTH and
low battery alerts for the remote controller or aircraft. Fly with caution.
Linking the Remote Controller
The remote controller is linked to the aircraft by default. Linking is only required when using a
new remote controller for the rst time.
1. Power on the remote controller and the aircraft, then launch DJI Pilot 2.
2. Tap Link to Aircraft to link. The status LED of the remote controller will blink blue, and the
remote controller will beep during linking.
3. Press and hold the power button on the aircraft for at least ve seconds. The aircraft power
indicator will blink to indicate linking has started.
4. The Status LED on the remote controller glows solid green if linking is successful. If linking
fails, enter linking status again and retry.
Image Transmission
The remote controller features O3 technology, which enables triple-channel 1080p Image
transmission and supports Single Operator or Dual Operator mode.
1. When in Single Operator mode, the remote controller supports dual-channel 1080p Image
transmission.
2. When in Dual Operator mode, the remote controller supports triple-channel 1080p Image
transmission and allows seamless swapping between input feeds.