dji FLYCART 30 - Manual Operation

DJI FlyCart 30 User Manual
©
2024 DJI All Rights Reserved.
79
Manual Operation
1. After securing the cargo and nishing the preight checks, control the aircraft during manual
takeo and then y to the destination.
2. When the aircraft reaches the destination, keep about 10 m between the ground and the
bottom of the cargo case. Tilt the FPV gimbal downward, and the AR projection will allow the
user to see the situation on the ground.
3. Make sure the surroundings are safe and the area is suitable for landing, then land the
aircraft and take out the cargo.
Cruise Control
After pressing the C3 button during flight, the aircraft will enter cruise control and fly
automatically, and no operation is needed. Press the C3 button again to exit cruise control.
Dual Operation Mode
Set the remote controller at the takeo point to A and the remote controller at the destination
point to B. If the signal strength is weak or the landing condition is complicated, remote
controller B can obtain ight control to control the aircraft when it is in sight.
Usage
1. Set the remote controller to A or B on the homepage of DJI Pilot 2.
2. Press once on the aircraft authority button of remote controller B. When the indicator turns
green, it indicates that aircraft control has been obtained and remote controller B is able to
control the aircraft.
• Press and hold the aircraft authority button of remote controller A to lock the aircraft
control. When the indicator turns blue, the indicator on remote controller B will blink
white, which indicates that remote controller B cannot obtain aircraft control. Press once
on the aircraft authority button of remote controller A to release the aircraft control lock.