dji FLYCART 30 - Page 25

DJI FlyCart 30 User Manual
©
2024 DJI All Rights Reserved.
25
Advanced Features
Calibrating the Compass
The compass may need to be calibrated after the remote controller is used in areas with
electromagnetic interference. A warning prompt will appear if the compass of the remote
controller requires calibration. Tap the warning prompt to start calibrating. In other cases,
follow the steps below to calibrate your remote controller.
1. Power on the remote controller and enter the home page.
2. Select System Settings, scroll down, and tap Compass.
3. Follow the on-screen instructions to calibrate the compass.
4. A prompt will be displayed when the calibration is successful.
HDMI Settings
The touchscreen can be shared with a display screen via an HDMI cable. The resolution can be
set by entering Settings, Display, and then Advanced HDMI.
Dual Operator Mode
FlyCart 30 aircraft supports Dual Operator mode that allows two pilots to operate an aircraft
simultaneously using remote controllers A and B. In this mode, both remote controllers can
have equal control of the aircraft. The remote controller that has aircraft control can control all
aircraft operations, while the other remote controller has no control over the operation of the
aircraft and will only display a live view of operation.
Setting the Dual Operator Mode
Before using Dual Operator mode, the pilot needs to link the aircraft with both remote
controller A and remote controller B. Follow the steps below to link the remote controllers.
1. Run the DJI Pilot 2 app.
2. Enter the homepage and tap Remote Controller A/B to activate linking. During linking, the
status LED of the remote controller blinks blue and the remote controller beeps. Press and
hold the power button on the aircraft for at least ve seconds. The aircraft power indicator
will blink and beep twice to indicate that linking has started. When linking is successful,
the aircraft status indicators will blink green, the remote controller will beep twice, and the
remote controller status LED turn solid green.
3. Thereafter, the aircraft authority button on the remote controller with control of the aircraft
will turn green, and the aircraft authority button of the other remote controller will turn white.
• Link the two remote controllers one by one. Make sure to link remote controller A with
the aircraft rst, and then link remote controller B.
Using Dual Operator Mode
1. Make sure both remote controllers are linked and connected with the aircraft before using
Dual Operator mode. Remote controller A has aircraft control by default, and the user using
remote controller B can only view.
2. Either pilot can take over control of a device as needed. Press once on the aircraft authority
button on the remote controller to obtain aircraft control. To lock the aircraft control, press
and hold the aircraft authority button. The aircraft authority button turns to blue after the
aircraft control is locked.