dji FLYCART 30 - Page 35

DJI FlyCart 30 User Manual
©
2024 DJI All Rights Reserved.
35
e. PinPoint Information: Displays the name of the PinPoint and the horizontal distance
from the aircraft to the PinPoint, when PinPoint is enabled.
Displays the name of the waypoints, the horizontal distance from the aircraft to the
waypoint, and the ascending or descending trajectory of the ight route, during a ight
route.
Vertical Obstacle Sensing Information: When an obstacle is detected above or below
the aircraft, an obstacle bar icon will appear. When the aircraft reaches the warning
distance, the icon will glow red and orange. When the aircraft reaches the obstacle
braking distance, the icon will glow red.
Horizontal Obstacle Sensing Information: The light areas are the obstacle sensing areas
of the aircraft, while the dark areas are the blind spots. During ight, keep the aircraft
speed vector line out of the obstacle-sensing blind spots. When the aircraft reaches
the warning distance, the arc will glow orange. When the aircraft reaches the obstacle
braking distance, the arc will glow red. When the obstacle sensing is disabled, OFF will be
displayed.
13. Map View
Tap to switch to map view.
a
g
b
c
d
e
f
a. Tap to draw lines on the map.
b. GEO Zone Layer Management.
c. Recenter Button: Tap to quickly center the remote controller in the view.
d. Tap to lock the map rotation with north pointing upward.
e. Map Layer Selection: Tap to select a satellite or street map (standard mode) according to
operation requirements.
f. Tap to clear the ight track of the aircraft.
g. PinPoint: Press the L1 button on the remote controller to add a PinPoint in the center
of the view. The altitude is the current altitude of the aircraft. Tap the PinPoint to check
the distance from the aircraft, the altitude, and the coordinates. The PinPoint can be set
as Home Point, pin and alternate site. Setting the PinPoint as a pin will make it easier to