DJI Goggles 3 User Manual
©
2024 DJI All Rights Reserved.
23
7. GNSS Status
Displays the current strength of the aircraft GNSS signal.
If the devices are not used for an extended period of time, it may take longer than usual to
search for the GNSS signal. If the signal is unobstructed, it takes approximately 20 seconds
to search for the GNSS signal when powering on and off within a short period of time.
When the icon is white, the GNSS signal is strong. When the icon is orange, the GNSS signal
is weak. When the icon is red, the GNSS signal is extremely weak.
8. Vision System Status
Displays the vision system status of the linked aircraft, this icon varies according to the
aircraft model. The icon is white when the vision system is working normally. Gray and red
respectively indicates that the vision system is turned o or working abnormally, note that
obstacles cannot be avoided at this time.
9. Video Bitrate
Displays the current video bitrate of the liveview.
10. Remote Controller and Image Transmission Signal Strength
Displays the signal strength of the remote control device, and the image transmission signal
strength between the aircraft and the goggles.
The icon is white when the signal is strong, and turns gray when the signal is lost.
The icon is orange when the signal is moderately weak, and turns red when the signal is
extremely weak. A prompt bar of the same color is displayed in the bottom of the ight
liveview.
11. Remaining Flight Time
Displays the remaining ight time of the aircraft.
12. Aircraft Battery Level
13. Distance to the Ground
Displays the current altitude information of the aircraft from the ground when the aircraft
is less than 10 m above the ground.
14. Flight Telemetry
Displays the horizontal distance (D) between the aircraft and the Home Point, height (H)
from the Home Point, aircraft horizontal speed, and aircraft vertical speed.
15. Flight Modes
Displays the current ight mode.
16. Home Point
Indicates the relative position of the Home Point.
To Next Page
Loading...
Need help?
General
