dji GOGGLES 3 - Compatible Products; Risk and Warnings

DJI Goggles 3 User Manual
©
2024 DJI All Rights Reserved.
39
Energy
21.6 Wh
Charging Temperature
0° to 50° C (32° to 122° F)
Max Charging Power
20 W (charging when powered o)
Runtime
[4]
Approx. 3 hours
[1] Some countries and regions prohibit the use of the 5.1GHz or 5.8GHz frequency band, or both. In some
countries and regions, the 5.1GHz frequency is only allowed for indoor use. Before ying, make sure to
check and comply with local regulations.
[2] Measured in an open outdoor environment without interference. Actual data varies with dierent aircraft
models.
[3] Measured in an outdoor open environment without interference. Actual data varies with the operating
environment.
[4] The 3-hour max operating time was measured at an ambient temperature of 25° C (77° F), screen
brightness at 4, connected to the DJI Avata 2 aircraft, video transmission set to 1080p/100fps, Head
Tracking o, Real View o, and the goggles fully charged and not supplying power to external devices
such as smartphones.
Compatible Products
Visit the following link to view compatible products:
https://www.dji.com/goggles-3/faq
Risk and Warnings
When the aircraft detects any risk after powering on, there will be a warning prompt on the
goggles screen. Pay attention to the prompt during ight and take necessary actions accordingly
to avoid product damage or risk of injury.
If the Signal Lost Action of the aircraft is set to RTH, when the control signal or transmission
is lost during ight, the aircraft will automatically initiate Failsafe RTH and y back to the last
recorded Home Point.
In emergency situations during ight, such as if a collision occurs, a motor stalls, the aircraft
rolls in the air, or the aircraft is out of control and is ascending or descending quickly, the
motors can be stopped by pressing the motion controller lock button four times.
• Stopping motors mid-ight will cause the aircraft to crash. Operate with caution.
If the goggles screen goes off unexpectedly during flight, press the motion controller lock
button once to brake the aircraft rst, and then initiate RTH manually. After the aircraft is back,
check the goggles power level and try to restart the goggles. If the problem persists, contact DJI
support.