dji GOGGLES 3 - Settings

DJI Goggles 3 User Manual
©
2024 DJI All Rights Reserved.
27
number will be displayed when Broadcasting mode is enabled so that other devices
can nd the device and enter the channel to see the ight liveview.
b) Disable the Focus mode, or set to auto. (only supported by certain aircraft)
c) Set the Channel mode to auto or manual. It is recommended to select auto so that the
video transmission will automatically switch between dierent frequency bands and
select the channel with the best signal (some aircraft only support a single frequency
band).
d) Set the frequency band. If the channel mode is set to manual, either 2.4 GHz
or 5.8 GHz can be selected (some aircraft only support a single frequency
band).
e) Set the bandwidth of the video transmission. The number of channels available
varies according to the bandwidth. The channel with the best signal strength can be
manually selected. The higher the bandwidth, the higher video transmission rate
and clearer image quality. However, there will also be a higher chance of wireless
interference and the amount of equipment that can be accommodated will be more
limited. To avoid interference in a multiplayer competition, manually select a fixed
bandwidth and channel.
• If any nearby video transmission device turns on the Broadcasting mode, the device and
its signal strength can be viewed in the Audience sub-menu. Select a channel to see the
ight liveview.
4. Settings
• Safety
a) Set the safety congurations such as max ight altitude, max ight distance, and RTH
altitude. Users can also update the Home Point, set the obstacle avoidance behavior (if
the aircraft supports obstacle avoidance), and view the IMU and compass status of the
aircraft or the goggles and calibrate them if necessary.
b) Camera View Before Loss helps to nd the location of the aircraft on the ground by
using the cached video of the aircraft 30 seconds before signal is lost. If the aircraft
still has signal and battery power, turn on ESC beeping to locate the aircraft using a
beeping sound that is emitted from the aircraft.
c) Advanced Safety Settings include the following:
• Aircraft Signal Lost Action: The aircraft behavior can be set to hover, land, or RTH
when the remote controller signal is lost.
• AirSense: The goggles will notify users if there is a civil airplane approaching in
nearby airspace. This function is enabled by default. DO NOT disable it.
• Emergency Propeller Stop (disabled by default): When enabled, the motors of
the aircraft can be stopped mid-flight anytime once the user presses the motion
controller lock button four times. If the switch is disabled, the motors can only be
stopped with this action in an emergency, such as if a collision occurs, a motor
stalls, the aircraft rolls in the air, or the aircraft is out of control and is ascending or
descending quickly.
• Stopping motors mid-ight will cause the aircraft to crash. Operate with
caution.