dji Matrice 100 - Optional Battery Compartment Mounting

12
©
2015 DJI. All Rights Reserved.
DJI MATRICE 100 User Manual
Optional Mounting Position - On Top of the Center Frame
1. Take the Aircraft Status Indicator cable, CAN cable, signal cable and power cable of the ight
controller out of its existing wire outlet. Pull the cables through the wire outlet on the upper plate of
the center frame instead.
2. Re-mount the upper plate onto the center frame and tighten the 16 screws (M2.5x5). Orientate the
upper plate so that the notch faces the left of the aircraft (with its tail facing you). Then mount the
mounting rails and tighten the 8 screws (M2.5x8).
If you are using the DJI Zenmuse X3 Gimbal with Camera, install the gimbal before mounting
the upper plate. Refer to Mounting the Gimbal (P20) for more details.
Flight Controller Power Cable (4-pin)
Flight Controller Signal Cable (6-pin)
Upper Plate
Wire Outlet
Aircraft Status Indicator Cable (6-pin)
CAN Cable (5-pin)
Aircraft Status Indicator