DJI Mavic 3 User Manual
54
©
2021 DJI All Rights Reserved.
Auto Takeo/Landing
Auto Takeo
Use auto takeo:
1. Launch DJI Fly and enter the camera view.
2. Complete all steps in the pre-ight checklist.
3. Tap . If conditions are safe for takeo, press and hold the button to conrm.
4. The aircraft will take o and hover 1.2 m above the ground.
Auto Landing
Use auto landing:
1. Tap . If conditions are safe to land, press and hold the button to conrm.
2. Auto landing can be cancelled by tapping .
3. If the Vision System is working normally, Landing Protection will be enabled.
4. Motors stops after landing.
Stopping the Motors
There are two methods to stop the motors.
Method 1: When the aircraft has landed, push and hold the left stick down. The motors will stop after
three seconds.
Method 2: When the aircraft has landed, push the left stick down and perform the same CSC that was
used to start the motors. The motors will stop immediately. Release both sticks once the
motors have stopped.
Starting/Stopping the Motors
Starting the Motors
A Combination Stick Command (CSC) is used to start the motors. Push both sticks to the bottom
inner or outer corners to start the motors. Once the motors have started spinning, release both sticks
simultaneously.
OR
Method 1 Method 2
OR
To Next Page
Loading...
Need help?
General
Weight and Dimensions
