DJI Mavic 3 User Manual
44
©
2021 DJI All Rights Reserved.
Linking the Remote Controller
The aircraft and remote controller must be linked before using. Follow these steps to link a new remote
controller:
1. Power on the remote controller and the aircraft.
2. Launch DJI Fly.
3. In camera view, tap
and select Control and Pair to Aircraft (Link).
4. Press and hold the power button of the aircraft for more than four seconds. The aircraft beeps once
indicating it is ready to link. The aircraft beeps twice indicating linking is successful. The battery level
LEDs of the remote controller will glow solid.
Make sure the remote controller is within 0.5 m of the aircraft during linking.
The remote controller will automatically unlink from an aircraft if a new remote controller is linked to
the same aircraft.
Fully charge the remote controller before each ight. The remote controller sounds an alert when the
battery level is low.
If the remote controller is powered on and not in use for ve minutes, an alert will sound. After 6
minutes, the aircraft automatically powers o. Move the control sticks or press any button to cancel
the alert.
Adjust the mobile device holder to ensure the mobile device is secure.
Fully charge the battery at least once every three months to maintain battery health.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
