dji Mavic 3M - Page 22

DJI Mavic 3M User Manual
22
©
2023 DJI All Rights Reserved
.
Critical Low Battery
Level Warning
Tap
> in
camera view to
set the critical
low battery level
threshold value.*
Short beeps will sound from the remote
controller. The user can still control the
aircraft. It is unsafe to continue flying the
aircraft. Land immediately.
* The threshold value is different from that of Low Battery RTH or auto landing.
The colored zones and the estimated remaining flight time on the battery level indicator
are automatically adjusted according to the aircraft’s current location and status.
Failsafe RTH
The action of the aircraft when the remote controller signal is lost can be set to RTH, land,
or hover in DJI Pilot 2. If the Home Point was successfully recorded and the compass is
functioning normally, Failsafe RTH automatically activates after the remote controller signal
is lost for more than six seconds.
When the lighting is sufficient and the vision systems are working normally, DJI Pilot 2 will
display the RTH path that was generated by the aircraft before the remote controller signal
was lost and return to home using Advanced RTH according to the RTH settings. The aircraft
will remain in RTH even if the remote controller signal is restored. DJI Pilot 2 will update the
RTH path accordingly.
When the lighting is not sufficient and the vision systems are not available, the aircraft will
enter Original Route RTH.
Original Route RTH Procedure:
1. The aircraft brakes and hover in place.
a. If the aircraft is farther than 50 m from the Home Point, the aircraft adjusts its
orientation and flies backward for 50 m on its original flight route before entering
Straight Line RTH.
b. If the aircraft is farther than 5 m but less than 50 m from the Home Point, it enters
Straight Line RTH.
c. The aircraft lands immediately if it is less than 5 m from the Home Point when RTH
begins.
2.
3. The aircraft lands and the motors stop after reaching the Home Point.
The aircraft will enter or remain in Straight Line RTH if the remote controller signal is
restored during RTH.