To Next Page

To Previous Page

Installer in DMG format supports only Mac OS X 10.6 or above.

Usage of PHANTOM 2 Assistant on Mac OS X and Windows are exactly the same. The Assistant pages

appear in other places of this manual are on the Windows for example.

7.2 Using the PHANTOM 2 Assistant on a PC

1. Start up the PC, power on the PHANTOM 2, then connect the PHANTOM 2 to the PC with a Micro-USB

cable. DO NOT disconnect until configuration is finished.

2. Run the PHANTOM 2 Assistant and wait for the PHANTOM 2 to connect to the Assistant. Observe the

indicators on the bottom of the screen. When connected successfully, the connection indicator is

and communication indicator is blinking .

3. Choose [Basic] or [Advanced] configuration pages.

4. View and check the current configuration in the [View] page.

Language swap

View configurations

Connection indicator

Communication

indicator

RC, Gain

Gimbal, Battery

IMU calibration

Firmware upgrade

Account, software

version

*This image is for reference

only. Please refer to the

actual user interface.

Function switch of Phantom 2

and Naza-M mode

dji PHANTOM 2 User Manual

Questions and Answers: