To Next Page

To Previous Page

ZENMUSE L1

User Manual

2021

Storage, Transportation, and Maintenance

Storage

The storage temperature range for the L1 LiDAR is from -40° to 85° C (-40° to 185° F). Keep L1 LiDAR

sensors in a dry and dust-free environment.

1. Make sure the L1 LiDAR sensors are not exposed to environments containing poisonous or

corrosive gases or materials.

2. DO NOT drop the L1 LiDAR sensors and be careful when placing in or taking out of storage.

Transportation

1. Before transportation, place the L1 in a suitable box for transportation and make sure it is secure.

Make sure to place foam inside the transportation box and that the box is clean and dry.

2. DO NOT drop the L1 and be careful when carrying it.

Maintenance

1. Under normal circumstances, the only maintenance required for the L1 is to clean the optical

window of the LiDAR sensor. Dust and stains on the optical window can negatively affect the

performance of the LiDAR sensor. Make sure to regularly clean the optical window to prevent this

from happening.

2. First, check the surface of the optical window to see if cleaning is necessary. If it is necessary to

clean it, follow the steps below:

A. Use compressed or canned air. DO NOT wipe a dusty optical window as it will only cause more

damage. Clean the optical window with compressed or canned air before wiping the optical

window. It is not necessary to use a wipe if there is no visible stains on the optical window

afterward.

B. Wipe the stains: DO NOT wipe using a dry lens tissue as it will scratch the surface of the optical

window. Use a wet lens tissue. Wipe slowly to remove the dirt instead of redistributing it on the

surface of the optical window. If the optical window is still dirty, a mild soap solution can be used

to gently wash the window. Repeat Step B to remove any remaining soap residue.

Other manuals for dji ZENMUSE L1

Questions and Answers:

Need help?

Do you have a question about the dji ZENMUSE L1 and is the answer not in the manual?

General