To Next Page

To Previous Page

2021

Using This Manual

Legends

Important Hints and Tips Reference

Caution

1. The L1 is a precision instrument. DO NOT drop the L1 and handle with care.

2. If highly accurate point cloud data is required, it is not recommended to use the L1 in low visibility

conditions such as foggy or rainy weather. Otherwise, the detection range may be reduced resulting

in point cloud noise being produced.

3. DO NOT touch the optical window of the L1. Dust and stains on the optical window can negatively

affect the performance. Use compressed air or a wet lens cloth to clean the optical window

correctly. Refer to the Storage, Transportation, and Maintenance section for more information on

how to clean optical windows.

4. DO NOT touch the surface of the lens with your hand. Be careful to avoid scratching the surface of

the lens with sharp objects. Otherwise, the quality of images may be aected. Clean the surface of

the camera lens with a soft, dry, clean cloth. DO NOT use substances containing alcohol, benzene,

thinners, other ammable substances, or alkaline detergents to clean or maintain the RGB Mapping

Camera or Auxiliary Positioning Vision Sensor.

5. When not in use, store the L1 in the storage case and replace the desiccant packet as necessary to

prevent fogging the lenses due to excessive ambient humidity. If the lenses fog up, the water vapor

will usually dissipate after powering on the device for a while. It is recommended to store the L1 in

an environment with a relative humidity of less than 40% and temperature of 20±5° C.

6. DO NOT place the product under direct sunlight, in areas with poor ventilation, or near a heat

source such as a heater.

7. DO NOT repeatedly power the product on or o. After powering o, wait at least 30 seconds before

powering back on. Otherwise, the product life will be aected.

8. Under stable laboratory conditions, the L1 achieves an IP54 protection rating by IEC 60529

standards. The protection rating is not permanent, however, and may reduce over an extended

period.

9. Make sure there is no liquid on the surface or in the port of the gimbal.

10. Make sure the gimbal is securely installed on the aircraft and the microSD card slot cover is closed

properly.

11. Make sure the surface of the gimbal is dry before opening the microSD card slot cover.

12. DO NOT remove or insert the microSD card when taking a photo or recording a video.

Other manuals for dji ZENMUSE L1

Questions and Answers:

Need help?

Do you have a question about the dji ZENMUSE L1 and is the answer not in the manual?

General