DLab RE100-Pro - 6. Faults

13
Release Lift-up/Lift-down key, the lift stops.
• Push the speed key and then rotate control knob to set
the rated speed.
• Push the temperature key and then rotate control knob
to set the rated temperature.
• Push the timer key and then rotate control knob to set
the rated time.
Deactivate the timer by setting the target value to “0”.
• Press the Int key and then rotate control knob to set the
rated interval value.
Deactivate the interval by setting the target value to
“0”.
• Press the control knob, switch ON.
If these operations above are normal, the device is ready to
operate. If not, the device may be damaged during
transportation, please contact manufacturer/supplier for
technical support.
Warning !
Forbid to transfer the flask when the instrument
working.
6. Faults
• Instruments can’t be power ON
- Check whether the power line is unplugged
- Check whether the fuse is broken or loose
• Fault in power on self test
- Switch OFF the unit, then switch ON and reset
the instruments to factory default setting.
• ERR 003, lift operation timeout
- Load overweight
• ERR 005, lift can’t work
- Check whether the transportation lock is loosen
- Load overweight
If these faults are not resolved, please contact
manufacturer/supplier.